AllBlu tests and balances pool water for homeowners in Wellington and nearby Palm Beach County communities. We check sanitizer, pH and the other levels that keep water clear, then add only what your pool needs. Balanced water is more comfortable to swim in, easier on your equipment and much less likely to turn cloudy or green.
Clear water is not always balanced water. A pool can look fine while the pH drifts high, the chlorine runs low or the stabilizer builds up. Those problems show up later as eye irritation, scale on the tile, stains or an algae bloom. Regular testing catches the drift before you can see it.
What We Test and Adjust
Every pool is a little different, but these are the levels we watch most closely. The ranges below are typical targets for a residential chlorine pool. We adjust them for your pool’s size, finish, sanitizer system and how much it gets used.
- Free chlorine. This is the sanitizer doing the work. A typical target is about 1 to 3 parts per million (ppm), adjusted for the stabilizer level.
- pH. Keeps the water comfortable and lets chlorine work well. A typical range is 7.2 to 7.8, with many pools kept around 7.4 to 7.6.
- Total alkalinity. Acts as a buffer that holds pH steady. A typical range is about 80 to 120 ppm.
- Calcium hardness. Too low can etch plaster, too high can leave scale. A common target is roughly 200 to 400 ppm.
- Cyanuric acid (stabilizer). Protects chlorine from the sun. Common targets fall around 30 to 50 ppm, and it should not be allowed to climb too high.
- Salt level. For saltwater pools, we check that salt is in the range your system’s manufacturer calls for so the cell can make chlorine.
After testing, we add what the water needs and note the readings, so changes over time are easy to spot.
Why Pool Chemistry Is Harder in South Florida
Water chemistry in Wellington moves faster than in cooler climates. A few reasons:
- Sun and heat. Strong sunlight breaks down chlorine, and warm water speeds up how fast it is used.
- Afternoon storms. Heavy rain dilutes chemicals and can push pH and alkalinity out of range in a single afternoon.
- Runoff and debris. Fertilizer, soil and leaves washed in by rain feed algae and use up sanitizer.
- Spring pollen. Pollen clouds the water and adds organic load the chlorine has to handle.
- Busy swim days. Sunscreen, sweat and more swimmers all increase demand on the sanitizer.
Because these changes stack up, a pool can go from clear to cloudy in a few days during the summer. Testing every week keeps up with that pace.
Signs Your Pool Water Is Out of Balance
Call us if you notice any of these:
- Cloudy or hazy water, even after the filter has been running
- A green or yellow tint, or slippery spots on the walls or steps
- A strong chlorine smell, which usually means the chlorine is busy fighting contaminants, not that there is too much
- Burning eyes or itchy skin after swimming
- White crust or scale on the tile line or equipment
- Stains or discoloration on the pool surface
These are signs the chemistry needs attention. The longer they go, the harder and more expensive they are to correct.
Chemical Service and Equipment Go Together
Good chemistry depends on good circulation and filtration. If the pump is not running long enough, the filter is dirty or a salt cell has stopped producing chlorine, the chemicals cannot keep up no matter how carefully they are added. When the water will not stay balanced, we look at the equipment too. AllBlu handles pool pump and motor repair, so the same team can fix the cause instead of adding more chemicals to cover it.
Chemical balancing is included in our weekly cleaning visits, and it is also available for homeowners who handle their own skimming and brushing but want help keeping the water right. See all of our pool services.
Pool Chemical Service FAQs
How often should pool water be tested?
In South Florida, at least once a week is a good baseline, and more often after heavy rain, a pool party or a stretch of very hot weather. Weekly testing is part of every AllBlu cleaning visit.
Why does my pool smell like chlorine?
A strong chlorine smell usually comes from chloramines, which form when chlorine reacts with sweat, oils and other contaminants. It often means the pool needs more sanitizer, not less. Testing tells us what the water actually needs.
Is it safe to swim right after chemicals are added?
It depends on the product and the amount. Some adjustments are fine to swim in shortly after they circulate, while a shock treatment needs time for chlorine levels to come back down. We let you know when the pool is ready to use.
Do saltwater pools need chemical service?
Yes. A salt system makes chlorine, but pH, alkalinity, stabilizer and calcium still need to be tested and adjusted, and the salt level has to stay in range. Saltwater pools also tend to see pH rise over time, so regular checks matter.
Get Your Pool Water Balanced
Let AllBlu keep your water clear, comfortable and easy on your equipment all year. We serve Wellington and nearby Palm Beach County communities with water testing, chemical balancing, weekly cleaning and equipment repair. Learn more about AllBlu and owner Alec Rizzo.